Sprinkler irrigation is the irrigation system in which water required by the plant is sprayed like rain under the defined pressure. Water is transferred to sprinklers. Individual sprinkler system consists of the water source, pump, main pipeline, vertical pipeline, and sprinklers. Sanbor Sprinkler Irrigation Pipes which are produced according to TS EN 12201-2 quality standard is made of high-density polyethylene (HDPE) and produced with 50-160 mm diameters and 5-6 meter length. Operating pressure is 6 atmospheres. The montage of SANBOR Sprinkler Irrigation Pipes is easy. They can be combined when the plastic seals and the clips at two sides are combined. Advantages Since there is no water loss in the system, water is used in the maximum level in the places where irrigation water is low (3.5 lt/sec). It can provide irrigation without erosion in slopped lands. Since the water is given to the soil with the rain effect, 20%-50% increase is observed in corp yield compared to other irrigation methods and quality is high. -During seed germination, the inability of the plant to reach above ground due to the layer created on the soil is prevented. Ideal irrigation system in the soils with low depth and (shallow) permeable soils. At the places closer to the sea, salt particles left by the sea water carried by wind, dust and insects can be washed via rain. Since there is the opportunity to control water via sprinkler irrigation, it is the best irrigation method at the places whose groundwater level (drainage) is high. Since there is no need for field ditches, planting area increases and agricultural works can easily be operated. Vegetables, citrus, vineyards and other orchards can be protected from frost and heat. Dissoluble fertilizers can be applied to vegetables with the irrigation water without extra work Areas of Usage It is used in the irrigation of slopped lands, wine yards, and gardens, vegetable, citrus and other orchards. Things to take into account While carrying, it should not be lifted and thrown. Clamps and clips can be broken. It can stay under solar rays and be used in the fields during summer. No problem is observed. Pipes should be stored at the possible temperatures between +5°C and +45°C. Before using the seals for pipe connection, seal recesses should be cleaned. The seal should be completely placed. High pressure created in motor pump outlets cause the removal of seals in the pipes. Pressure should be kept under control with a manometer. The promised pressure values on our pipes are under our warranty. In case of higher pressure levels than the indicated ones, the possible problems that can be created are not covered by the warranty