Introduction Babbitt alloys remain consistent from edge-to-edge and end-to-end through thousands of pounds of ingots and bars, and through thousands of miles of spray wire. Babbitt formulations meet or exceed their engineering standards. With higher productivity, less rework, less cleanup. Fewer defects and higher quality finished products. The coatings are ductile, low in oxides and exhibit a bright, metallic appearance. It can equivalent to: tafa 04t, sulzer metco spraybabbit Surface preparation Surface should be clean, white metal, with no oxides (rust), dirt, grease, or oil on the surface to be coated. Note: it is best not to handle surfaces after cleaning. Recommended method of preparation is, to grit blast with 24 mesh aluminum oxide, rough grind, or rough machine in a lathe. Application Bearing surfaces Product details Chemical composition: Type Chemical composition Sn Sb Cu Other Babbitt wire 90 7~8 3~4 0.25 Specifications Grade Aws Babbitt wire C2.25 / c2.25m w-snsbcu-1 Physical properties Grade Density Melting point Babbitt wire 6.67 g/cm3 354 °c Typical deposit characteristics: Typical hardness Bond strength Deposit rate Deposit efficiency Machilityineab Nil 3000 psi 48 lbs /hr/100a 70% Good Standard sizes & packing: Diameter Packing Wire weight 1/8(3.17mm) D 300 spool 15kg(33 lbs)/spool Other sizes can be produced by customers' requirement.