WALL GUARD PUTTY is a white cement based product with redispersible polymer and functional additives for application on interior and exterior rough plasters to give a smooth finish. FEATURES :- WALL GUARD PUTTY 1. Provides smooth and uniform finish to rough plasters 2. Good Workability 3. Does not require curing with water 4. Good water resistance 5. Good Tensile Adhesion Strength, Compressive Strength and Flexural Strength 6. Controlled water vapour permeability 7. Excellent abrasion resistance 8. Resists growth of algae and fungi on wall 9. Good intercoat adhesion to emulsion paints RECOMMENDED APPLICATION :- It can be used on all types of exterior cement plasters/interior walls, asbestos sheets, concrete etc PRODUCT TECHNICAL DATA :- COLOURS : White FINISH : Smooth and Matt COVERAGE : 2 coats: 10-15sq.ft/KG up to 1.5 mm thickness in two coat (It may vary from the quoted coverage to factor such as method and condition of application and surface roughness) DRYING TIME : 6-8 HOURS GLOSS LEVELS/SHEEN LEVELS : Silky smooth sheen FLASH POINT (IS101/108 Part 1, Sec 9) : Non- flammable SUITABILITY OF THINNER PAINT Use within 24 hrs. SHELF LIFE 3 years from date of manufacture in original tightly closed containers kept away from direct sunlight and excessive heat. PERFORMANCE DATA :- ABRASION RESISTANCE : Excellent WATER RESISTANCE : Excellent SHELF LIFE : 3 years from date of manufacture in original tightly closed containers away from direct sunlight and excessive heat. REMARKS : a) Kindly refer to the MSDS for the Saffro Mellow Coatings And Resinswhich gives detailed information on Safety measures while handling the paint. b) Store the product at ambient conditions in well ventilate locations and away from the source of ignition and fire. c) Avoid eye and skin contact. In case of eye and skin contacts, wash with plenty of clean water. d) Do not inhale or inject. In case of inhalation move to fresh air and seek medical attention. e) Use protective equipments like rubber/polythene gloves, safety goggle/glasses, face mask while handling the paint. f) In humid areas, use of a bio-wash solution is recommended to remove surface fungus growth, fungal spores, mould etc. before application of the paint system. g) Do not apply when ambient temperature is less than 10�ºC or if the temperature might drop to this level within 4 hrs of application. h) Tinted paints need thorough shaking/mixing immediately after tinter addition as well as before use. i) For removing stains, sponge clean with a mild soap solution and wipe clean. Ensure drying time of 1 Week before cleaning.