Question: How do I reset the drive back to factory default settings? Answer: Go to parameter A1-03 and set value 2220 for 2 wire control or 3330 for 3 wire control (Please refer to Step 6 for wiring diagram) Question: How do I adjust the time it takes the motor to speed up or slow down? Answer: Adjust the acceleration time parameter C1-01 and deceleration time C1-02. Question: How do I prevent my drive from tripping on an OV fault (overvoltage) while my motor is ramping down? Answer: Increase deceleration time parameter C1-02. Question: How do I prevent my drive from tripping on an OL1 fault (overload) while my motor is ramping down? Answer: Verify motor rated current parameter E2-01 and motor overload parameter settings L1-01 Motor overload selection, L1-02 Motor overload protection time.