NEOFLON PFA AP-210 is excellent in melt flowability and is suitable for injection molding and extrusion molding. Introduction - AP-210 is a copolymer of tetrafluoroethylene and perfluoroalkyl vinyl ether. - Good melt flowability while maintaining excellent properties of PTFE. It can be melt-molded as a thermoplastic resin by injection molding and extrusion molding. - Excellent chemical resistance which is not affected by most of the chemicals. - Excellent heat resistance. Continuous use temperature is 260 â??. - It retains flexibility without losing toughness under the environment from cryogenic to high temperature. - Low dielectric constant and dielectric loss tangent in a wide range of temperature and frequency. - It shows high electrical resistance and dielectric strength. - Nonflammable like POLYFLON PTFE and NEOFLON FEP. - Excellent weather resistance. No properties change even when exposed outside for a long time. - Non-stickiness. It shows excellent releasability and water repellency / oil repellency.