En590 Jet A1 Suppliers and Manufacturers

We are a direct mandate to reputable refineries in Qatar, Kazakhstan, USA. for the supply of petroleum and gas products. We are a company that has brought ingenious buyers to refineries, transacting with a standard specification and international trading procedures. At this moment we are glad to inform you that on behalf of our highly esteemed refineries, We are here to take away your stress of recent market. Kindly reach out to us for more enquiries; AVILABLE PRODUCTS: LIGHT CYCLE OIL, DIESEL EN590,EURO 6 (10PPM), GAS OIL D2 L0, 2-62, VIRGIN FUEL OIL D6,AVIATION KEROSENE GRADE 54, JET FUEL A1, LPG - LIQUEFIED PETROLEUM GAS, LNG â??LIQUEFIED NATURAL GAS, MAZUT M100, CRUDE OIL REBCO, EAST SIBERIAN PACIFIC BASIN CRUDE OIL (ESPO), PETROLEUM COKE, GRANULAR UREA 46%.

Property Specification Density @ 15 C 775 - 840 kg/m Flash Point Minimum 38C Freezing Point Maximum -47C Viscosity @ -20C Maximum 8.0 mm/s (cSt) Smoke Point Minimum 25 mm Aromatics Content Maximum 25% by volume Sulfur Content Maximum 300 mg/kg Hydrogen Content Minimum 13.4% by mass Total Acidity Maximum 0.015 mg KOH/g Electrical Conductivity 50 - 600 pS/m (if required) Lubricity (BOCLE) Minimum 0.85 mm Thermal Stability (JFTOT) Minimum 260�°C (Filter Pressure Differential: Maximum 25 mm Hg) Water Content Maximum 70 mg/kg

Aviation Jet Fuel is a type of aviation fuel designed for use in aircraft powered by gas-turbine engines. It is colourless to straw coloured in appearance. The most commonly used fuels for commercial aviation are Jet A and Jet A1, which are produced to a standardised international specification. The only other jet fuel commonly used in civilian turbine-engine powered aviation is Jet B, which is used for its enhanced cold-weather performance. Jet fuel is a mixture of a variety of hydrocarbons. Because the exact composition of jet fuel varies widely based on petroleum source, it is impossible to define jet fuel as a ratio of specific hydrocarbons. Jet fuel is therefore defined as a performance specification rather than a chemical compound. Aviation Jet Fuel is commonly referred to as JP54. However, this is the wrong terminology as there is no such grade of Jet Fuel. Jet A and Jet A1 are what refineries offer. Aviation Jet fuel Gas is what powers turbine aircraft engines. Worldwide, Jet Fuel is the most used low Sulphur content Kerosene. For instance, Colonial JP54 is similar to Jet A except the energy is 18.4 mj/Kg compared to the 42.8 MJ/kg of Jet A. Most importantly there is also a slight difference in additives. Aviation Jet Fuel B is used for its extremely cold weather performance. However, aviation Jet fuel Bs lighter composition makes it more dangerous to handle. For this reason, it is rarely used except in very cold climates. A blend of approximately 30% Kerosene and 70% Gasoline. Because of its very low freezing point (60 C (76 F), it is known as a wide cut fuel and has a low flash point as well. Aviation Jet Fuel B is primarily used in some military aircraft. In Canada, it is also used because of its freezing point. Aviation Kerosene standards are published as GOST10227-86. The standard consists of different properties. It separates paraffin and gasoline in the refinery. Military organisations around the world use a different classification system of JP (for Jet Propellant) numbers. Some are almost identical to their civilian counterparts and differ only by the amounts of a few additives. For instance, Jet A1 is similar to JP 8, Jet B is similar to JP 4. Military fuels are highly specialised products and are developed for very specific applications. Jet fuels are sometimes classified as kerosene or naphtha type. Kerosene type fuels include Jet A, Jet A1, JP 5 and JP 8. Naphthatype jet fuels, sometimes referred to as wide cut Jet Fuel, including Jet B and JP 4.

Aviation Jet Fuel is a type of aviation fuel designed for use in aircraft powered by gas-turbine engines. It is colourless to straw coloured in appearance. The most commonly used fuels for commercial aviation are Jet A and Jet A1, which are produced to a standardised international specification. The only other jet fuel commonly used in civilian turbine-engine powered aviation is Jet B, which is used for its enhanced cold-weather performance. Jet fuel is a mixture of a variety of hydrocarbons. Because the exact composition of jet fuel varies widely based on petroleum source, it is impossible to define jet fuel as a ratio of specific hydrocarbons. Jet fuel is therefore defined as a performance specification rather than a chemical compound. Aviation Jet Fuel is commonly referred to as JP54. However, this is the wrong terminology as there is no such grade of Jet Fuel. Jet A and Jet A1 are what refineries offer. Aviation Jet fuel Gas is what powers turbine aircraft engines. Worldwide, Jet Fuel is the most used low Sulphur content Kerosene. For instance, Colonial JP54 is similar to Jet A except the energy is 18.4 mj/Kg compared to the 42.8 MJ/kg of Jet A. Most importantly there is also a slight difference in additives. Aviation Jet Fuel B is used for its extremely cold weather performance. However, aviation Jet fuel Bs lighter composition makes it more dangerous to handle. For this reason, it is rarely used except in very cold climates. A blend of approximately 30% Kerosene and 70% Gasoline. Because of its very low freezing point (60 C (76 F), it is known as a wide cut fuel and has a low flash point as well. Aviation Jet Fuel B is primarily used in some military aircraft. In Canada, it is also used because of its freezing point. Aviation Kerosene standards are published as GOST10227-86. The standard consists of different properties. It separates paraffin and gasoline in the refinery. Military organisations around the world use a different classification system of JP (for Jet Propellant) numbers. Some are almost identical to their civilian counterparts and differ only by the amounts of a few additives. For instance, Jet A1 is similar to JP 8, Jet B is similar to JP 4. Military fuels are highly specialised products and are developed for very specific applications. Jet fuels are sometimes classified as kerosene or naphtha type. Kerosene type fuels include Jet A, Jet A1, JP 5 and JP 8. Naphthatype jet fuels, sometimes referred to as wide cut Jet Fuel, including Jet B and JP 4.

The JET A-1 is type of aviation fuel, also called JP-A1, is used globally in the turbine engines[jet engines, turboprops] in civil aviation. ofr more information, contact Boggash Investment Limited as their official handles or website, thank you

Available products: JET A1/JP54, CRUDE OIL, D2, D6, EN590, DIESEL 10PPM & 50PPM, BITUMEN, MAZUT M100, Copper. Safe procedure and long-term cooperation - that is our motto. As an experienced team based in Berlin, with direct contacts to refineries and direct clients, I and my team ensure a smooth procedure. For us, the customers are the focus of everything we do. To be successful, we need to know what our buyers need. We want to ensure that we offer our buyers added value with our solutions. We meet our commitments and meet our deadlines and goals. Send us LOI so that we can start processing the order. If you have any questions please do not hesitate to contact us! Available products: -JET A1 -JET JP54 -Diesel D2 Automotive, -EN590 10 PPM, -Diesel D6, -Diesel 10PPM & 50 PPM. -Mazut M100 -Bitumen -Crude Oil -Copper

Sugar Icumsa 45 (PLEASE READ THIS CAREFULLY - NO BROKERS NO TIME WASTERS.) We have two offers available for the month of May. Icumsa 45 - 200.000 MT monthly contract U$ 410 CIF VHP 600-1200 200.000 MT Monthly contract U$ 460 CIF Both contracts are direct refinery contracts. once SPA is signed and Payment is verified sugar will go into production This is a direct refinery contract in the state of Sao Paulo Brazil. CIS only required to start the process. Once end buyer is verified, he will be contacted for a factory visit. Payment SBLC from a TOP 50 bank or wire / cash deposit in full. The contract (SPA) will be signed in the factory and Payment will be made to the refinery's bank of choice.

Sugar VHP 600-1200 We are now accepting contracts from 50.000 to 300.000 Price is U$ 450 Per MT quarterly contract (renewable) Payment SBLC TOP 50 or 30%- 70% This is a direct refinery contract in the state of Sao Paulo Brazil. CIS only required to start the process. Once end buyer is verified, he will be contacted for a factory visit. The contract (SPA) will be signed in the factory and Payment will be made to the refineryâ??s bank of choice. No past performance or BL will be provided (Pop is direct refinery contract.) We dont EXPORT sugar we only sell EX WORKS.

Sugar icumsa 45 and VHP We can offer quantaties from 5.000 MT up to 300.000 MT per month on contracts or as spot order.

We supply Jet A1 Fuel, ULSD Diesel EN590, Unleaded Gasoline and Fuel Oil... ORIGIN: EUROPEAN .... Price: Platts minus 7% ... We can supply as CIF, STS and Vessel Take Over. The Seller is The Owner and the TITLE HOLDER ... SBLC MT760 is accepted as NON-TRANSFERABLE, NON-OPERATIVE and is issued to the SELLER (not to a fiduciary).. We're looking for RWA buyers... MOQ is 50,000 MT for EN590, FUEL OIL, and Gasoline, and 2M bbl for Jet A1 Fuel .... Contact: Usama