Plywood, osb, scaffolding, phone & accessories, poker game.
Vsat equipment, 1.8m c band antenna, buc, lnb, hnx modem.
USB flash drives.
Integrated circuits.
PC phone call account, PC phone.
LED series (MR 16, T8).
Laptops.
Projection screens, computer peripherals & media products.
LED light bulbs, LED T8 tubes, LED flood lights, LED high bay, LED street light, LED emergency light, LED track light, LED downlight, LED ceiling light.
Bearing, oil seals, timing belt, pulley, chain and sprocket, gearbox and motors..Manufacturer
Refurbished computer, LCD Monitor, CRT monitor , clone computer.
CD-R , DVD-R, Scrap HMS 1/2, iron.
Computer hardware, laptop.
Graphic Design, Printing & Equipment Supplies.Shipping
Pioneer and jvc car audio product, video camera, water heater.
Air Conditioner, LED, LCD TV, fans.
Computer, mobile phone, water filtration system.
Charcoal, RBD palm olein, LED flooring, cement, steel, power banks.Ground logistics
Desktop, laptop, Punjabi suits, ladies garments, imitation jewellary, palm oil, palm kernel, soap noodles.
Core steel plate Specification for core steel plate 1.0Scope 1.1 this specification covers the grain oriented electrical steels are iron-silicon alloys that provide Low core loss and high permeability needed for more efficient and economical electrical Transformers. Cold rolled grain oriented (crgo) grades of electrical steel are typically used For transformer cores and large generators. 2.0Application 2.1 the cgro is used regularly for cores in transformers. 3.0Standard 3.1 this specification is prepared by taking guidance from bs 601:1973 4.0Material 4.1 cold rolled grain oriented (crgo) grade m5, moh, zdkh as per bs 601:1973 and Equivalent to jis c 2553 5.0Properties 5.1 specifications and typical electrical and magnetic properties (see appendix 1) 6.0Dimension and tolerance 6.1 dimension : as per the purchase order with the tolerance as given table below Tolerance on width Nominal width (mm) OverUp to and includingTolerance (mm) 0150+ 0 0.3 150500+ 0 0.5 001000+ 0 1.5 Tolerance on length Nominal width (mm) OverUp to and includingTolerance (mm) 02000- 0 + 1.5 2000>2000- 0 + 2.0 Tolerance on length The tolerance on the mean thickness, measured by contact micrometer, for any coil shall be + 0.03 mm from the nominal thickness. Tolerance on edge burr The tolerance on edge burr not to exceed 0.05mm. Tolerance on edge camber Edge camber is the lateral departure of the edge of the strip from a straight line forming a chord, refer figure a: Tolerance on edge camber of strip in coil shall not exceed 2 m in 2000 mm and shall be measured against a straight edge using a 2000 mm length cut from a coil. 7.0References (1) bs 601: 1973, steel sheet and strip magnetic circuits of electrical apparatus. As provided above