Shaft : Single Rated voltage : DC 24V Input power : 20W Revolution per minutes : Max 1350 R.P.M. Rotation : CW/CCW Magnet : Permanent magnet Bearing : Ball Bearing Storage temperature : 5~95% RH Operation temperature : 0-55 Insulation grade : E Energy efficiency : The first level
High Efficency Power Supply
DC Brushless Motor Application
Arcing is eliminated. Connect the red battery clamp to the positive battery terminal. Connect the black Clamp to the negative or ground to a rigid metallic surface on the engine. The connection should be 12 to 19 inches from the battery. 4.Hose: Since the pump has a lower discharge pressure it is ., recommended that anoncolapsiable hose be used for maximum pumping capacity. 5.Hoisting & lowering: Use the attached nylon line. Do not use the power cord ., for handling the unit. 6.Operation of unit: Lower the unit into the liquid to be pumped(note: this unit is not to used to pump Flamable liquids).Then turn on the switch. Pump can be run for a few minutes(less than 5) without liquid. Do not run completely dry for any extended period(less than 5 min.).This will prevent. 7.Running time peroids: The unit draws 20-25 amperes and can be operated for approximately 1 hr. On a fully charged 60 amp-hour battery and still be able to start the vehicle under normal conditions. Caution should be used when running times exceeds 25 !v 30 minutes without the engine running to recharge the battery. Also be mindful of cold temperatures which lowers battery
Spe3 series 1/3 hp effluent pumps 1.1/2" solids handling 2.Heavy duty lip & mechanical seals in tandem 3.115 & 230 volts available 4.60hz 5.Durable cast iron motor housing 6.115 & 230 volt piggyback power plug and switch Plug w/20' cord as standard
Dsgp1-2021-60hz Dsgp1-2023-60hz 2 hp grinder pump 1.Double mechanical seal 2.Silicon carbide (main) !v grit 3.Resistant 4.Carbon ceramic (secondary) 5.Dual sealing chambers with 6.Moisture detection for optimum 7.Motor protection ductile iron 8.Impeller, recessed, clog-free 9.30 year proven design 10.Stainless steel grinder assembly 11.Effectively macerates domestic 12.Into a fine slurry
Dshhgp1-2021-60hz 2 hp grinder pump 1.Ideal for long discharge runs or high static heads 2.2 piece motor housing 3.Separate cord cap assembly 4.Internal capacitors - no control box req'd ductile iron impeller, recessed, clog-free dual silicon carbide seal - grit resistant stainless steel grinder assembly effectively macerates domestic sewage into a fine slurry 5.30 year proven design
Digp-7023/7043-60hz (patented) 1.Available with 2.7.5 hp grinder pump 3.High head, double stage 4.Doubled output pressure 5.Unmatched performance 6.350 shut-off head 7.Flows to 100 gpm 8.Balanced design 9.Ideal for long discharge runs or high static 10.Heads 11.Potentially replaces higher hp pumps 12.Ductile iron impeller, recessed, clog-free 13.Silicon carbide seals !v grit resistant
We are professional motor manufacturer and earned much reputation in the treadmill motor field. Our products range cover from ac induction, pmdc, a/dc universal, low voltage battery, gear reduced and customized motors. General export cartons.
Headlamp leveling motor. 1pc In 1 Bubble Wrap ,100pcs In 1 Outer CTN.
Diffuser is designed for matching with the ready made local 4/8" faucet, easy to install. Tough and durable construction. Higher oxygen dissolution rate and corrosion resistance. Prevent backflow and clogging. Material: 1. Diffuser cover:neoprene rubber, resisting against acid and alkali. 2. Diffuser base:abs Specifications: 1. Bore:4/8'' - thread, 3/8'' - air inlet. 2. Diameter:80mm 3. Height:40mm 4. Ventilation volume:0.08 ~ 0.10 m¦/min -
Features: 1. Lower noise:pressure pluses are the major noise source in blowers. The trundean roots blower design can efficiently reduce noise by approximately 5 db. 2. Lower energy consumption:trundean roots blower are designed to control backflow pressure to the rotor in order to reduce energy consumption. 3. Longer bearing life:less vibration transmitted through the lobe results approximately 20% longer bearing life. -
Features:: 1. Quietness:because of its submergibility under water, so there will be not much noise from the machine when in use. 2. No need of a silencer:because of its under water, the created noise will be very low, so there will be no need to do silencer. Under-water can mean space-saving. 3. Strong structure, be relieved:the direct connect between the motor and the blower can avoid the inconvenience of traditionally-done belt adjustment. 4. Lower energy consumption:trundean roots blower are designed to control backflow pressure to the rotor in order to reduce energy consumption. 5. Longer bearing life:less vibration transmitted through the lobe results approximately 20% longer bearing life. -
Features: !e superior combination of materials and a leak-free, seamless design. !e excellent corrosion resistant materials such as carbon, ceramics etc. !e designed with an emohasis on improved durability. !e excellent corrosion resistant. !e featuring enhanced reliability and safety. !e the series can be arranged with nema or iec standard motor. !e easy maintenance disassembly and assembly -
Vacuum pump improved by raising the intensity in order to prevent cent rotor and axis deviation from external influences. Features: 1. Lower noise:pressure pluses are the major noise source in blowers. The trundean roots blower design can efficiently reduce noise by approximately 5 db. 2. Lower energy consumption:trundean roots blower are designed to control backflow pressure to the rotor in order to reduce energy consumption. 3. Longer bearing life:less vibration transmitted through the lobe results approximately 20% longer bearing life. -
Shaft type water pump for concrete mixer - heavy equipments Wooden case
Vibration motor
Variable speed drive
Gear motor
DC to DC converters, AC to DC power supply module, DC to AC power inverter.
