Water pump WOODEN, BOXES
Tiller Model WM500 Body Size (mm) 1380 í- 650 í- 970 N.Wú¿ kg ú¬ 60/74 Tilling Scope(mm) 500-1000 Tilling Depth(mm) 150-250 Gear Shifting 0,1,2/-1,0,1/0,1,2,-1 Transmission Type Belt Transmission Oil Capacity (L) 0.95 Engine Engine Model WM168FB Boreí-Strokeú¿mm ú¬ 68 í- 54 Displacementú¿ml ú¬ 196 Compression Ratio 8.5 ú¦1 Max.power output HP/rpm 6.5 ú¿ 4.8ú¬ /3600 Max.Torque (M.m/rpm) 13.2/2500 Fuel Oil capacityú¿ L ú¬ 3.6 Engine Oil capacityú¿ L ú¬ 0.6 Min.fuel consumption g/KW. h 395 Air cleaner model semi-dry,oilbath,foam filter element Ignition system Transistor magneto Engine model OHV25 ípSingle cylinder,4-stroke Packing Dimension (mm) 820 í- 375 í- 780 20 FT(set) 123 Note with wheels and mud fender Certificate GS,CE Dimension:820*375*780mm
CQB-F Series Fluoroplastic magnet pump adopts the permanent magnet into centrifugal pump. The pump has the advantages such as fully sealed and no leakage and anticorrosion etc. CQB-F Series Fluoroplastic magnet pump is made of PVF2. The material has the good anticorrosion and high mechanism intensity and no aging and no toxin distribution etc. The pump uses the stationary seal to substitute the rotary seal. The flow passage parts are in full seal to insure no leakage. The pump has the compact structure and good appearance and low noise and small volume and steady operation etc. The pump is widely used to transport acid and alkali and oil etc rare liquids and toxin and volatile liquids in chemical industry and pharmacy and electroplate and food and photo etc and water circulation system and filter system. It is especially for flammable and explosive and leaky liquids. Plywood case
MP Series minitype magnet pump is fully sealed without mechanical seal. The magnetism material in shaft and impeller attract each other for coincidence. Torsion of motor is driven by active magnet and passive magnet to let impeller work. Ceramic bearing has very good wearable and anticorrosion performance. The pump is widely used to transport acid and alkali and oil and rare liquids and toxin and volatile liquids in chemical industry, pharmacy,petroleum, electroplate,food, photo etc and water circulation system and filter system. The pump without explosion proof motor is especially for flammable and explosive and leaky liquids. Plywood case
The wet parts of this pump are made of full stainless steel material to perform outstanding corrosion resistance to organicacid,organic compound,alkali,neutral solution and a great many of gases. double helix carbon graphite bearing and hard alloy bearing are provided with good abrasion-resisting property to ensure the service life of product.It is an optimal pump for handling corrosive mediums without leakage. plywood case
CQ Series magnet pump is the new centrifugal pump used with magnetic coupling. The material of magnet pump has the stainless steel and reinforced polypropylene and engineering plastic etc. The pump has the advantages of reasonable design and entire seal and no leak and anticorrosion characteristic. The rotary seal replaces the stationary seal to insure no leak because the parts which contact with liquids are entirely sealed. Magnet pump is made of engineering plastic with anticorrosion and high strength and ceramic and stainless steel to insure good anticorrosion performance. Magnet pump has single structure and good appearance and small volume and low noise and reliable operation. The pump is widely used to transport the acid and alkali and oil and toxin and volatile liquids in chemical industry, pharmacy, petroleum, electroplate and food, etc. It is very suitable for leaky and flammable and explosive liquids. Plywood case
Zcq series self priming type magnet pump is the magnet pump with 4meter self priming height but it need not install foot valve and pour guide water. Rotary ring replaces stationary ring so that parts which contact with liquids are entirely sealed and no leak. Pump body and parts which contacts with liquids are stainless steel and ceramic and teflon etc material to insure the good anticorrosion performance Plywood case
Monoblock Inline Multistage Immersion Submersible Air tank compressors
KF-O/1/2 SERIES PERIPHERIAL PUMP KF-O0/1/2 series water pumps have peripheral type impeller. On the extremities of the extremities of the impeller there are several radial paddles of the impeller and the pump body. This characteristic enable the pump obtaining a regular and not pulsating flow and high pressures with quite slopping curves. Working conditions Max Temperature of Fluid up to+80 Max pressure:10bar. Max Ambient Temperature up to 40 Standard data and equipment: Single phase 220v/50Hz,Brass or plastic impeller,carbon steel motor shaft,with thermal protector inside. Other model and material such as three phase,110v,60Hz,dual voltage, stainless shaft, etc, will be available upon request.
QB/PM SERIES PERIPHERIAL PUMP QB/PM series are suitable for pumping clean water. They are particularly suitable for domestic applications as supply water from well, pool etc,It is also suitable for water pressure boosting,gardening and automatic water suppiying system if composed with other appliances. Working conditions Max Temperature of Fluid up to+80 Max pressure:10bar. Max Ambient Temperature up to 40 Standard data and equipment: Single phase 220v/50Hz,Brass or plastic impeller,carbon steel motor shaft,with thermal protector inside. Other model and material such as three phase,110v,60Hz,dual voltage, stainless shaft, etc, will be available upon request.
4SD4 Series Stainless Steel Submersible Pumps For water supply from wells or reservoirs. For domestic use, for civil and industrial applications, for garden use and irrigation. Working conditions Water temperature up to 55íµ. Minimum internal diameter of well: 102mm Maximum immersion depth: 40m
WRS Series Pipe Pume These series are WRS pumps.The WRS pump is an air venting pump.It is equipped with an air vent tousing,suitable for using in conjnction with any commercially available automatic air went,vertical mouning of the air vent at any pump position.Motor overload protection is not required.The motor operates non-overloading. These pumps are suitable for heating water to VDI 2035 and water/glycol mixtures up to a ration of 1:1,They are extremely reliable,economical and quiet to use,being particulary suitable for domestic applications such as central heating installations,industrial circulating systems,air conditioning and chilled water circulation systems,etc. Working conditions Fluid temperature rang:-10+110 Maximum ambient temperature:40 Manual 3-speed control
QXN Water-Filled Submersible Pump
WQ/WQD SERIES SUBMERSIBLE PUMP WQ/WQD series submersible sewage pumpa are widely used in agriculturer, architecture, mine, environment protection and industry, such as drainage slurry, waste water, which contained short fibre, wastepaper, sand and so on. It is also an ideal equipment for irrigation. The normal power standard is 220v/50Hz single phase, 220V/380V/50Hz three phase. Three phase 230V400V/50Hz/60Hz, single phase univoltage 230V,240V,or 127V,110V,115V. Models are available on request.
LWD Series Submesible Pump These series submersible pumps are a kind of end-suction submersible electrical motor pumps which with close-coupled motor and pump. Pumps designed as Korea style, durability, and excellent performance. They are ideal portable water pumping equipment. They are suitable for agriculture, mining enterprise, building construction sites and households etc.
LWJ Series Submesible Pump These series submersible pumps designed as Korea style, the pump can be separated from the kickstand. When using, transfer the pump onto the kickstand which can be fixed in the sinkhole, and after using, the pump can transfer out then cleanout.. These pumps are suitable for apartment , and also agricultureíóbuilding construction sites and households etc.
WQD SERIES SUBMERSIBLE PUMP WQD submersibe pumps can be used for garden watering,oxygenating of cluster box or in supplying and draining water for ordinary places and characterized by corrosion resistance,small volume,light weight and convenient operation.It is fitted with multiple water-outlet pipes,and self-regulated according to the requirements of its lift and flow,and can deadlock(it is fitted with a floating switch,so it is possible to carry out the automatic control of start-stop action under no one care). The normal power standard is 220V/50Hz single phase, 220V/380V/50Hz three phase. Three phase230V/400V/50Hz/60Hz, singe phase uni-voltage 230V,240V,or 127V,110V,115V.Modes are available on request.
High quality Competitive price Packing: Standard export package or neutral packing (1)Based on CCR brand (2) High quality (3) Competitive price (4)Packing: Standard export package or neutral packing
Max ambient temperature up to 40 Max fluid temperature up to 80 Max pressure up to 10 bar Q.max (l/min) H.max (m) S.Head (M) N.W(kg) PACKAGE DIMENSION&GW HP kW 220V-1 50Hz A B H Kg QB60 0.3 0.22 1.6 8 2850 36 36 9 5.1 280 135 175 5.5 QB70 0.75 0.55 3.7 14 2850 46 60 9 8.5 320 175 200 9 QB80 1 0.75 4.6 20 2850 50 72 9 10 320 175 200 10.5 QB90 2 1.5 6.5 30 2850 70 85 9 21 425 220 255 22
Water pump We're manufacturer specilizing in fan clutch/water pump in shanghai china, our products are mainly exported to germany, uk, usa, canada, etc. We have high quality products with most competitive factory prices. I'm sure we can be your better choice once you try our fan clutches. Samples are available before you place order. Application cars: Mbz, Bmw, Audi, Opel, Ford, Toyota, Nissan, Mazda, Isuzu, Mitsubishi, Suzuki,
