Metallized YIG Microwave ferrite substrate
Technical requirements:
1- The Ferrite Thickness should be 0.37mm.
In the process of ferrite production, fine grinding method should be used.
The surface of the ferrite should be polished (To reduce the roughness).
Material:CY1780
2- Use a soft gold coating.
Clad layer: Cu1m4mAu2.5m5.7m.
The plating thickness should be 8~10m(Red area ).
3- The bottom side will be attached to a Gold plated carrier by soldering. The solder paste model can be Pb63Sn37.
The carrier material is Iron. Clad layer: Cu36mNi14m Au12m.
The final carrier dimensions (after plating) are 12mm X 9mm X 0.5mm.
4- The resistive layer should be 75 Ohm/Sq. The final resistor should be 50 Ohm (+/-10% tolerance) (Green area)
Features
High-Density design for 1U-24 port keystone panel
Compliant with the ANSI/TIA-568.2D Cat.6A requirement
RJ45 8P8C 50u" Jack
23-26 AWG strandred and solid wires range
T568A and T568B wring
Dust prevent shutter
Features
High-Density design for 1U-24 port keystone panel
Compliant with the ANSI/TIA-568.2D Cat.6A requirement
RJ45 8P8C 50u" Jack
23-26 AWG strandred and solid wires range
T568A and T568B wring
Dust prevent shutter
Product Feature:
It is equipped with multi-layer filter and activated carbon , high efficiency and filter PM2.5 and purify air.It can used with a silent fan,suitable for a variety of small hidden installation environments.
PRODUCTS INFO:
Type:POPULA FX Series Purifying Box
Brand:POPULA
Electric Current:AC
Voltage:1HP/3HP 110V/220V/380V/440V/3KV/6KV
Frequency: 50/60HZ
Air Volume:100-2000 M3/h
Air Pressure:30-180 Pa
Max Noise:
The 3500/15 AC and DC Power Supplies are half-height modules and must be installed in designated slots on the left side of the rack. The 3500 rack can contain one or two power supplies with any combinations of AC and DC. Either supply can power a full rack.
When two power supplies are installed in a rack, the one in the lower
slot acts as the primary supply, and the other in the upper slot acts as the backup supply. If installed, the second supply is the backup for the primary one.
Removing or inserting either power supply module does not disrupt operation of the rack as long as a second power supply is installed.
The 3500/15 AC and DC Power Supplies accepts a wide range of input
voltages and converts them to voltages acceptable for use by other
3500 modules. The following power supplies are available with the 3500
Series Machinery Protection System:
Universal AC Power
High Voltage DC Power Supply
Low Voltage DC Power Supply
General Information
Product ID: 3BSE008516R1
Medium Description: AI810 Analog input Module, 8 channels
Technical Information: Supersedes 3BSE008516Z1
Product Type: I/O Module
Country of Origin: Estonia / India
Customs Tariff Number: 85389091
Length: 150 mm
Height: 150 mm
Width: 75 mm
Weight: 0.19 kg
