Outdoor / Indoor LED display, Outdoor / Indoor LED screen, LED mesh display, LED transportation inducement display, screen, Score board, LED gas, LED bus display.
Spot welder.
Product: al-ztw80a sbec Code: 3080201 1.Specification: 1.1 output :continuous current 80a , burst current 90a for 10 seconds1.2 battery cell :5-18nc/2-6lipo1.3 weight :87g1.4 bec output :5v/2a1.5 size :68*37*17mm(l*w*h) 2. Features: 2.1 extremely low internal resistance2.2 super smooth and accurate throttle linearity2.3 safety thermal over-load protection2.4 auto throttle shut down in signal lose situation2.5 supports high rpm motors2.6 power arming protection (prevents the motor from accidentally running when switched on)2.7 new advanced programming software
Porsche durametric diagnostic cable Shringking paper
The cirrus sr22 is a single-engine four- or five-seat composite aircraft built from 2001 by cirrus aircraft of duluth, minnesota. It is a development of the cirrus sr20, with a larger wing, higher fuel capacity, and a more powerful, 310-horsepower (231 kw) engine. The sr22 has been the world's best-selling general aviation (ga) airplane every year since 2002. It is the most-produced ga aircraft made from composite material, accounting for over 30% of the entire piston aircraft market General characteristics Crew: one Capacity: four passengers Length: 26 ft 0 in (7.92 m) Wingspan: 38 ft 4 in (11.68 m) Height: 8 ft 11 in (2.72 m) Airfoil: roncz Empty weight: 2, 225 lb (1, 009 kg) Gross weight: 3, 600 lb (1, 633 kg) Fuel capacity: 92 us gallons (348 litres) Powerplant: 1 continental io-550-n six cylinder horizontally opposed aircraft engine, 310 hp (230 kw) Propellers: 3-bladed Performance Cruise speed: 183 kn (211 mph; 339 km/h) Stall speed: 60 kn (69 mph; 111 km/h) flaps down Range: 1, 049 nmi (1, 207 mi; 1, 943 km) with reserves at 65% power Service ceiling: 17, 500 ft (5, 300 m) Rate of climb: 1, 270 ft/min (6.5 m/s)
The robinson r22 is a two-bladed, single-engine light utility helicopter manufactured by robinson helicopter company. The two-seat r22 was designed in 1973 by frank robinson and has been in production since 1979. General characteristics Crew: 1 Capacity: 2, including pilot Length: 28 ft 8 in (8.74 m) Rotor diameter: 25 ft 2.4 in (7.67 m) Tail rotor diameter: 3 ft 6 in (1.07 m) Height: 8 ft 11 in (2.72 m) Disc area: 497 (46.2 m) Empty weight: 880 lb (399 kg[23]) Loaded weight: 920 lb (417 kg) Max. Takeoff weight: 1, 370 lb (635 kg) Main tank total capacity: 19.8 us gallons (75 liters) Main tank usable capacity: 19.2 us gallons (73 liters) Optional aux tank total capacity: 10.9 us gallons (41 liters) Optional aux tank usable capacity: 10.5 us gallons (40 liters) Powerplant: 1 ã? lycoming o-320-a2b or -a2c flat 4 piston engine, 124 hp (93 kw) Performance Never exceed speed: 117 mph, 188 km/h, 102 kts Cruise speed: 110 mph, 177 km/h, 96 kts Range: 240 mi (386 km) Service ceiling: 14, 000 ft (4, 267 m) Rate of climb: 1, 200 ft/min (6.1 m/s) Disc loading: 2.61 lb/ (13.7 kg/m) Fuel consumption: 8~10 us gal/hr Power/mass: 0.095 hp/lb (0.147 kw/kg) Endurance: approx. 3 hours, with 30-minute reserve
The cessna citation mustang, model 510, is a very light jet (vlj) class business jet built by cessna aircraft company at their independence, kansas production facility. The mustang, in standard configuration, has four passenger seats in the aft cabin, a toilet, and seating for two in the cockpit. Like most other light jets, the mustang is approved for single-pilot operation. General characteristics Crew: one or two pilots Capacity: 4 to 5 passengers Length: 40 feet 7 inches (12.37 m) Wingspan: 43 feet 2 inches (13.16 m) Height: 13 feet 5 inches (4.09 m) Empty weight: 5600 lb (2540 kg) Useful load: 3130 lb (1420 kg) Max. Takeoff weight: 8645 lb (3930 kg) Powerplant: 2 pratt & whitney canada pw615f turbofans, 1460 lb thrust (6.49 kn) each Performance Maximum speed: mach 0.63 (483 mph, 777 km/h) Cruise speed: 340 ktas (390 mph, 630 km/h) Range: 1167 nmi (at max. Takeoff weight) (1, 343 mi, 2, 161 km) Service ceiling: 41000 ft (12500 m) Rate of climb: 3010 fpm (917 mpm) Thrust/weight: 0.337 (at max. Takeoff weight) Takeoff distance: 3, 110 ft (948 m) Landing distance: 2, 380 ft (729 m)
Fiat Chrysler vehicles from 2018 may be equipped with a Security Gateway Module. This allows you to scan the vehicle for codes, but not the ability to clear codes or any active tests, bidirectional controls, or PIN read. With the Chrysler 8 Pin Male-8 Pin,12 Pin Male-12 Pin Female Extension Cable, you can access the vehicle network and perform all commands. This connector allows you to read and clear fault codes, view the data stream, active test, and ECU programming. With this Connector, you get a stable transmission and access to all the vehicleâ??s information. Stable Transmission: OBD2 Diagnostic Cable is a great replacement for the old cable, providing stable transmission and safe connection. Durable Material: Diagnostic cable connector is made of ABS and rubber material, anti aging, high flexibility, not easy to crack.
This just a small connector,do not have any software. Its not a scanner too. High quality OEM molds insure stable sockets that connect every time and dont wobble. 6- and 9-pin Adapter forTruck High-quality materials give the cable superior flexibility and durability.
Differrent trucks reqire differrent cables and connectors. The OBD 6+9Pin Green Heavy Duty Truck diagnostic cable features a 6Pin+9pin Male (J1978+J1739) to OBDII 16Pin Female connector. 6+9 truck cable 9in Easily switch between older and newer models. This cable is compatible with a wide range of heavy-duty trucks, buses, trailers, and more. We are a professional 6+9 truck cable 9in cable manufacturer with more quality assurance and price advantages.
OBD OBD2 Car Cable for autocom car
OBD OBD2 Car Cable for autocom car
Bicycle/parts, motorcycle parts and electric tools..
Air compressor air filter, oil filter, separator, transducer, valve, coupling.
Auto repair tool auto repair cable auto diagnostic programmer, auto diagnostics auto repair equipments.
Car jump starter, fridge freezer, booster cable, auto cable, phone holder, tow rope.
Metal & plastic parts of 3d printing, sheet metal fabrication, cnc machining services, parts for aerospace, automotive, consumer goods, medical, devices, robotics and other industries. learn more: https://www.tuofa cncmachining.com/.Manufacturer & exporter
Servo motor servo drive planetary gearbox.
Micro gear motors, micro gearboxes, micro gears.
DC gearbox motor, DC motor.
