With more and more attention on decorative style and creativity, chain link fence gate is widely used to decorate yards, gardens and to protect their property. The chain link fencing materials are durable and cost low and no maintenance. Chain Link Fence Gates Have Five Types: Walk Gate, Single Gate, Double Swing Gate, Cantilever Gate And Roll Gate. Black Chain Link Fence And Gates Technique Specifications: a) 1.2mt high black powder coated chain link fencing and gates as follows: Gate and end posts 40NB galvanized steel powder coated black Posts 32NB galvanized steel powder coated black 2.4mt centers Top rail 25NB galvanized steel powder coated black Attached to posts with black powder coated down fittings Chain wire galvanized steel black PVC coated, 60x60 diamond Bottom cable black PVC coated* 3 sets double gates 25NB frame powder coated black 3.2mt opening size, black chain wire infill. b) Gates is swing type, hinged to swing 180 degrees from closed to open, complete with frames, latches, stops, keepers, hinges, fabric, braces, and PVC coating wire mesh(50¡¨¢50), diameter 4mm. c) 42 x 42", 42 x 48", 48 x 48", 42 x 60", 42 x 72" single walk fence gate 1 3/8" tubing hot dipped galvanized 12' x 42", 12' x 48", 12' x 60", 12' x 72" double drive fence gate 1 3/8" tubing hot dipped galvanized 6' x 6', 6' x 12' kennel panel 1 3/8" tubing hot dipped galvanized Cattle/wrangler panels with bow gate and cattle wrangler panels with hardware attached: 18 gauge or 1.2mm thick. Galvanized then powder painted brown. Tube gates: 18 gauge or 1.2mm thick. Galvanized then powder painted brown. How To Make Chain Fence Gates If you do not want to buy a chain link fence gate and then do it by yourself, install it where you want to install. This is not difficulty things, so you can save a lot of spending. Tools used in the production process: tape measure, gate post hinges, gate fork latch, bolts, sockets, wrench, chain links, gate frame, brackets, solder, pliers. Here are chain link gate installation steps and tips. First: under the instructions, make a gate framework and the first part attached on the sliding belt. Then sliding parts are assembled door frame with your hands. Second: sliding a rod into the fence and through a coil. Third: attach the tension band and slide the second lever into the mesh. Make sure you slide it close enough to the opposite side rail to hold the mesh taut once you attach it to the tension bands. Fourth: unhook the strand of mesh that's near the outside second tension bar and pull it out, removing the excess mesh with pliers. Fifth: pull the mesh along with tension band tightly while slipping the tension bar into the tension bands on the frame of the gate with pliers, if the net is not tight enough the lever to into go to the next set of loops. Unravel the excess mesh and hook the bar back into the tension bands. Final: attach the tie line to the benchmarking of the top and bottom once the mesh is fixed in one place. A Cable line in the mesh around the hook with pliers, pulled the network cable has been slightly higher than the door frame to the network. Ensure let the tie cord around freely in the mesh around with pliers. Tips: his metal hardware must be ready to complete. In order to switch the gates must be to the height of the ground. Packages for fencing and accessories. We usually transport the fencing in rolls and accessories in decking.