TL-1 burning furnace is consists of 5 parts: natural gas burner + inner tank + insulation box + fan + control system. The burner forms a high-temperature flame after full combustion in the high-temperature resistant inner tank, these flame mixes with the cold or recirculated air to produce a new and high-temperature air. Under the action of the fan, it is discharged to provide heating for drying machines or places.
Advantages/features
1. Simple structure and low cost
2. Large air volume and small wind temperature fluctuation
3. Stainless steel high temperature resistant inner tank, durable
4. Automatic gas burner, complete combustion, high efficiency. (After setting up, the system can control the ignition+cease fire+temperature adjust automatic),
5. High-density fire-resistant rock wool insulation box to avoiding heat loss
6. High temperature and high humidity resistant fan with IP54 protection rating and H-class insulation rating.
TL-4 model Direct burning furnace with 3 layers sleeve consists of 3 layers of cylinders. It uses fully burned natural gas to obtain high-temperature flame, and mixing this temperature with fresh air to achieve the required hot air device. Due to the use of fully automatic single-stage fire, two-stage fire or modulating burner, the output hot air is extremely clean by natural gas fully burned, , meeting the drying and dehydration needs for most stuffs. The external fresh air enter the furnace body under negative pressure, takes two strokes and sequentially cools the middle cylinder and the inner tank. After being fully mixed with the high-temperature flame in the mixing zone, it is extracted from the furnace body and enter the drying room. When the temperature reach the setting number, the main burner stops working and the auxiliary burner continues to burn to maintain the temperature. When the temperature drops to the set lower limit temperature, the main burner will be run again. 4ã??Advantages/features 1. Simple structure and easy installation 2. Small air volume, high temperature, adjustable from normal temperature to 500â?? 3. Stainless steel high temperature resistant inner tank, durable 4. Automatic gas burner, complete combustion, high efficiency. (After setting up, the system can control the ignition+cease fire+temperature adjust automatic), 5. The fresh air has a long stroke that can fully cool the inner tank, so the outer tank can be touched without insulation. 6. Equipped with high temperature resistant centrifugal fan, large pressure center and long lift
TL-3 model Direct burning furnace with lower Inlet and upper outlet is consists of 8 parts: natural gas burner + inner tank + insulation box + fan + fresh air damper + waste heat recovery device + dehumidification fan + control system. It is specially designed for supporting downflow drying room/heating rooms. After fully combusts the natural gas inside the inner tank, it�´s mixed with recycle or fresh air, under the action of the fan, it is discharged from the upper outlet into the drying room or heating space. Then cooled air pass through the lower air outlet for secondary heating and continuous circulation. And when the humidity of circulating air reaches the emission standard, the dehumidification fan and fresh air damper will start simultaneously. The exhausted moisture and fresh air implement sufficient heat exchange in the waste heat recovery device, so the moisture is discharged and the fresh air with recovered heat enter the circulation system. 4. Advantages/features 1. Simple structure and easy installation 2. Large air volume and small wind temperature fluctuation 3. Stainless steel high temperature resistant inner tank, durable 4. Automatic gas burner, complete combustion, high efficiency. (After setting up, the system can control the ignition+cease fire+temperature adjust automatic), 5. High-density fire-resistant rock wool insulation box to avoiding heat loss 6. High temperature and high humidity resistant fan with IP54 protection rating and H-class insulation rating. 7. Integrating the dehumidification and fresh air system, heat loss is extremely small through by the waste heat recovery device. 8. Automatically replenish fresh air
TL-5 model Indirect burning furnace with 5 layers sleeves consists of 5 parts: a blower, flue gas induced draft fan, burner, five-layer sleeve body and control system. The flue gas in the furnace takes two rounds while the fresh air takes three rounds. Natural gas is burned through the burner to generate a high-temperature flame. Under the action of the flue gas fan, the heat is transferred to the heated air through the five-layer sleeve wall and dense fins, meanwhile the flue gas is discharging out the body after it´s temperature down to 150. The heated fresh air enter the sleeves through blower. After heat mix, the temperature rises to the setting number and sent out from the hot air outlet. 4ã??Advantages/features 1. Continuously provide pure air with constant temperature and constant pressure. 2. Temperature has a wide adjustable range: 40~300 3. Indirect heating, automatic operation, exhaust gas emissions meet the requirements 4. Reasonable design, compact structure, thermal efficiency up to 75% 5. Stainless steel high temperature resistant inner tank, durable
Supplier: 1 ) pp woven bags 2 ) pp woven fabric & pp woven rolls 3) bopp woven sack 4) fibc bag / jumbo bag 5 ) block bottom valve bag 6 ) block bottom bag with open mouth 7 ) jute bag 8 ) wheat flour 9 ) wheat flour maida 10 ) organic wheat flour 11) wheat flour type 55 to 65 12) ashirwad wheat flour
Heat Area - 100m2 Dimension(W*H*D) - 450*975*782mm Weight - 70kg Air inlet pipe - 50mm Air outlet pipe - 80mm Auto-burning Time - 13h-27h Fuel Consumption - 0.8-1.8kg/h Efficiency - 90% Hopper Capacity - 20kg Electronic consumption - 100-400w/h Rating voltage - 230v
SEAGRASS ROPE/ RAW SEAGRASS __________________ Color: Natural color Place of Origin: Vietnam Style: Dried. Usage: Main material for handicraft industry Size: 2,5-2,8mm, 3mm, 3,2-3,5mm, 4mm, 5mm, 6mm, 7mm, 8mm, 9mm Packing: Bag or Customer required. Payment: L/C, T/T, negotiable
Seagrass is natural eco - friendly biodegrade material from Vietnam. It's can be used to make various handicrafts like seagrass mat, seagrass basket, seagrass rug,... Origin: Vietnam Length: 1.6m - 1.8m Type: Dried seagrass material Color: Natural Size: 2,5-2,8mm, 3mm, 3,2-3,5mm, 4mm, 5mm, 6mm, 7mm, 8mm, 9mm Usage: Basket, furniture, handicraft Packing: 30 kgs/bundles or as customer's requirement
Specifications: Origin: Vietnam Color: Natural. Moisture: 8% max. Diameter: 1 - 22 mm. Length: 100m, 200m. Made from medium to long fiber. 100% natural, well-cut, smooth surface. Quantity capacity: 5*40ft container/ month. Packaging: each roll is wrapped by straps For more detailed product information.
Coir rope is a product made from coconut fiber, which is organic and environmentally friendly. Using coir rope in decoration, agriculture ... will contribute to making our living environment cleaner and more environmentally friendly. Wrap the coir rope around the stem to keep the plant warm, not to make the sap affected in cold weather. - Use coir rope suitable for vines. Endurance on 06 months. After use can be applied to the roots to cause soil moisture. - Use coir rope to decorate the web for high artistic efficiency. Coir discs will be bundled and tied up with rope. Each bundle consists of 50-100 pieces (depends on the thickness). The capacity of the container also varies, depends on the diameter of the discs. But 1 20ft container approximately can load 50,000 - 60,000 pieces Brand: 99 GOLD DATA
