1. Min. Trace width : 0.075mm
2. Min. Space between trace: 0.075mm
3. Min. Hole size: 0.25mm
4. Min thickness:
A) single sided: 0.07mm
B) double sided: 0.13mm
5. Dimension tolerance:
A)+/-0.05mm (metal tooling)
B)+/-0.10mm (cutting tooling)
6. Base materials: pi, pet
7. Conductor (copper thickness): 0.5oz., 10oz. And 20oz. (ra and ed copper)
8. Cover-layer: pi and pet (solder mask printing is available)
9. Adhesive material: epoxy, acrylic and polyester
10. Stiffener materials: fr-4, mylar and polyamide
11. Surface finishes: flash gold plating, selective gold plating and solder plating
USB 2.0 to type-c male FPV Flat Slim Thin Ribbon FPC Cable, USB 3.1 Type-c to standard USB A for FPV gimbal, Please notice that it is USB end NOT HDMI.FFC USB FPV flat slim thin USB cable, ideal for FPV gimbal rigs and applications in tight space/rooms, Can directly transmit AV signal and for sync and charging. Very soft, lightweight, flexible, thin slim USB cable. low profile. less than 5g.
Question: Hi is it possible to remove the USB and solder wires to the +5v and GND terminals by hand? Answer: Yes, the USB plug can be removed. you can unlock the latch /little black holder. It can be soldered. please be very swift and control the temperature around 200 degrees (lower temperature ) while soldering Question: Please can you confirm the length I ordered one and it was only 50mm (5cm) long, not 50cm as per the title. Answer: Hello It should be 50cm. please contact the seller and send them the photo for exchange (there is contact on the warranty card)
Board to board connectors Board to board connectors, pitch:0.4mm, 0.5mm 0.8mm, 1.0mm. 1.25mm
Supplier: PCB,Flex PCB,automotive FPC,Screen FPC,battery FPC,camera FPC,module FPC,antenna FPC ,keyboard FPC
Membrane switch 1. Maximum circuit rating: 35vdc, 100ma, 1w 2. Contact resistance: 10¬+~ 500¬+ 3. Insulation resistance: 100m¬+ at 100vdc 4. Dielectric withstand: 250rms (50~60hz per min) 5. Contact bounce:
Supplier: FPC connector, pin header, socket, mini jumper, memory card connector
Supplier: Membrane switch, fpc, touch screen, el back lighting
Buyer: Membrane switch
Membrane switch standard specification 1. Maximum circuit rating: 35vdc, 100ma, 1w 2. Contact resistance: 10 500 3. Insulation resistance: 100m at 100vdc 4. Dielectric withstand: 250rms (5060hz per min) 5. Contact bounce:
1. Maximum circuit rating: 35vdc, 100ma, 1w 2. Contact resistance: 10~ 500 ohm 3. Insulation resistance: 100m ohm at 100vdc 4. Dielectric withstand: 250rms (50~60hz per min) 5. Contact bounce:
