Concentric lay stranded conductor consisting of Aluminum Alloy 1350-H19 wires.
AAC conductor is also known as aluminum stranded conductor. It is manufactured from electrolytically refined aluminum, with a minimum purity of 99.7%. AAC is used mainly in urban areas where the spacing is short and the supports are close. All aluminum conductors are made up of one or more strands of aluminum wire depending on the end usage. AAC is also used extensively in coastal regions because it has a high degree of corrosion resistance
All Aluminum Alloy Conductor is used for primary and secondary overhead transmission and distribution services. This has been designed utilizing a high-strength aluminum alloy to achieve a high strength-to-weight ratio and better sag characteristic. The conductor has a higher resistance to corrosion than ACSR.
Stranded 6201-T81 high strength aluminum conductors, conforming to ASTM specifications B399 are concentric lay-stranded, similar in construction and appearance to 1350 aluminum alloy grade aluminum conductors, and has a greater resistance to abrasion than conductors of 1350 aluminum alloy
ACSR Aluminum Conductor Steel Reinforced is used as bare overhead transmission cable and as primary and secondary distribution cable. ACSR offers optimal strength for line design. Variable steel core stranding for desired strength to be achieved without sacrificing ampacity.
Aluminum alloy 1350-H119 wires, concentrically stranded around a steel core available with Class A, B or C galvanizing; aluminum coated (AZ); or aluminum-clad steel core (AL). Additional corrosion protection is available through the application of grease to the core or infusion of the complete cable with grease. Also available with Non Specular surface finish.
Aerial Bundle Cable (ABC) low voltage cable for overhead power distribution offering higher level of safety and reliability and lower power losses than bare conductors.
Phase Conductor: Concentric strand or compressed 1350-H19 conductor Neutral
Conductors: aluminum alloy 1350-H19,6201-T81, or ACSR conductors
Insulation: high density polyethylene (HDPE) or cross-linked polyethylene (XLPE).
1.Solid or stranded copper/aluminum conductor
2.Insulation with XLPE, PE, or PVC
3.For cables of two-phase or three-phase conductors, round or flat shape available
4.PVC inner COVERING
5.Concentric layer of helically layed copper/aluminum wires
6.Wrapping tape
7.Black XLPE, PE, or PVC jacket
The concentric cable is used in electric service entrance from the power distribution network to the meter pannel(especially where it is required to prevent electricity theft), and as feeder cable from the meter pannel to the distribution pannel.
This cable an be used in dry and wet places, outdoors or directly buried. It has a maximum operating temperature of 90�ºC and rated voltage of 600V&below.
