Measure single phase kwh
5(30)a, 110v/220v
Small volume, 6 digis, 35mm din
. General
Adl10 has a compact design din rail mounting kwh meter, and it is very easy to install. It is suitable to the electrical energy statistic and management of internal of factories, buildings, schools, hospitals etc..
Order example
Example:
Type: adl10-e
Network: single phase
Mode of wiring: directly
Un: ac 220v
In: 5 (30) a
-
Akh-0.66/k split current transformer
L product feature
Akh-0.66k series split current transformers are mainly used in reconstructing projects of urban and rural power grids. They can be mounted easily without removal of primary bus. They also can be operated with electricity, which prevents the normal utilization of electricity. Thus, they save the manpower, material resources and financial resources and improve the efficiency of users.< this series match with relay protection, measuring and metering equipment.
-
Product introduction
This series of battery management system mainly used in lithium battery powered electric vehicles, electric boats, and electric equipment. Real time monitoring of the cells voltage, the total voltage of the battery pack, the temperature of the cells, the charge and discharge current. Provide the cells balance management, charge and discharge control, heating and cooling management, and fault information alarm.The system can be connected to the computer through the rs485 interface, and the operating parameters of the system can be monitored and configured by the matching computer software.
The basic control strategy
(1) after power on by the switch, in the case of the battery system is operating normally, both the charge and discharge relays will be closed.
(2) when the battery pack and cell over charge protect voltage occurs, disconnect the charging relay, until reached the release voltage.
(3) when the battery pack and cell over discharge protect voltage occurs, disconnect the discharge relay, until reached the release voltage.
(4) when the charge over and under temperature protect occurs, disconnect the charging relay, until reached the release temperatur
(5) when the discharge over and under temperature protect occurs, disconnect the discharge relay, until reached the release temperature.
(6) when the charging over current protect occurs, disconnect the charging relay, it will not be released until next powered on.
(7) when the discharge over current protect occurs, disconnect the discharge relay, it will not be released until next powered on.
-
