Ature:remove all oil or grease, soluble contaminants and other foreign matter
All surfaces to be coated should be clean, dry and free from contamination
If applied on rusty surface, rusty layer thickness should be below 50mm, other than bottom surface processing requirements, without acid and sandblasting processing, catalytic reaction, to get black protective layer and solvent (acrylic acid, polyurethane, epoxy resin, alkyd resin, amino paint or water-based paint) match well, will not occur and paint color bleeding
Apply in nice weather, don't let coating contact any liquid like water or other solvent before completely dry
No painting be carried out in rainy day outdoor
If above 85% humidity please stop painting
Temperature of substrate should be above 5¡ãc
Lower temperature might not dry or cause long time to dry
•air spray:nozzle orifice range: 1.5 to 2.5mm
Nozzle pressure range: 0.3 to 0.5mpa
•airless spray:nozzle orifice range: 0.4 to 0.5mm
Nozzle pressure range: 12 to 15mpa
•features:brush: use soft brush
Recommended finish: rsl series
Storage temperature: 5 to 30¡ãc in well ventilated warehouse
Stir thoroughly before painting
Don't use any steel or other metal stick to stir paint
20l/barrel
Can be applied directly on rusty steel( rust layer ¡ü45um)!
Color and appearance: grey or others
Coating thickness um: 50¡à5mm
Solid content % : 69¡à3%
Overcoating interval: minimum: 4 hours max: unlimited
Recommended substrate conditions and temperature:
1.Remove all oil or grease, soluble contaminants and other foreign matter. All surfaces to be coated should be clean, dry and free from contamination.
2.If applied on the rusty surface, the rusty layer thickness should be below 45 um
3.Apply in good weather, don¡¯t let coating contact any liquid like water or other solvent before completely dry. No painting be carried out in rainy day outdoor , if the humidity is above 85%, please stop painting
4.The temperature of substrate should be above 5¡ãc, lower temperature might not dry or cause a long time to dry
Air spray:nozzle orifice: 1.5-2.5mm
Nozzle pressure: 0.3-0.5mpa
Airless spray:nozzle orifice: 0.4-0.5mm
Nozzle pressure: 12-15mpa
Brush : use soft bursh
Recommended finish: rsl series finish
Shelf life: 12 months
Over coating time
Substrate
Temperature 5¡ãc 15¡ãc 25¡ãc 35¡ãc 45¡ãc
Minimum interval 24hrs 7hours 4hours 3hours 2hours
Maximum interval Unlimited storage temperature : 5-30¡ãc in well ventilated warehouse
20l/barrel or 20kg/barrel