All grades of stainless steel scrap, mainly 304 and 316
Hot Selling Aluminium Ingot A7 99.7% & A8 99.8% best Price Aluminium Ingot A7 99.7% And A8 99.8%. Once the aluminum scrap is collected and sorted, it is placed into a melting furnace and turned into molten aluminum at temperatures ranging from 1300 to 1400 degrees Fahrenheit. This molten aluminum cast into large slabs called ingots or billets. And since aluminum never loses its performance or strength during the recycling process, the same piece of aluminum can enter the secondary production process time and time again, multiplying the cost savings and environmental benefits. Not only does secondary aluminum production use less energy, it reduces landfill waste, contributes much lower greenhouse gas emissions and greatly reduces costly international transportation.
The Tire derived Steel or Tire Wire Scrap is a light melting scrap obtained during the shredding and granulation process of used tires. Generally 10% - 20% of the weight of an old passenger car tyre usually consists of steel. An average shredding plant produces about 100-200 MT of steel tyre wire and its quality can vary according to technology, storing and management systems adopted by the producing plants. We can provide tire wire scrap that still contains up to 20% rubber/fiber. This percentage is detected by manual separation test. The material can be loaded loose in 40 HC container. For further details, please feel free to contact us.
Waste Specification: European Classification: E46 EWC Code: 19.01.02 Basel Code: B10 10 The material is loose steel scrap processed through an incinerating plant for domestic waste followed by magnetic separation, fragmentized into pieces and consisting partly of tin coated steel cans. At a visual inspection, the material is fragmentized, with iron and steel parts, resulting partly cut or in shredded form. The stock appears heterogeneous and contains all kind of cut or dismantled steel parts such as sheets, bars, frames, wires, bolts and other iron/steel household residues. The incinerated scrap is eventually oxidized, due to the thermal and cooling treatments, that the material has been submitted to. The burnt scrap also contains minor slag parts, ash and iron oxide, due to the recovery process. Such components are inherent and adhere to the scrap surface. The total impurities, can be sorted, but not fully removed. The consignment does not contain any type of arms, ammunition, mines, shells, cartridges, radioactive contaminated, or any other explosive material in any form either used or otherwise. The collected stock, is stored in open air, on cemented flooring. Due to the scrap dimensions and the material conditions, this particular scrap, should be carefully evaluated first, by the end users, to confirm its adequate recovery ratio and its suitability to be re-melted in the electric arc furnace. Please feel free to contact us for further details
PRODUCT DETAILS 1.Aluminum UBC/Extrusion Scrap 6063/Wire Scrap 99.99 SPECIFICATIONS: AL % 99.7 S % 0.4 FE % 0.25 MAX MG % 0.55 MAX CU % 0.05 MAX ZN % 0.05 MAX TI % 0.02 MAX PACKING : COMPRESSED CUBE 0.5 M3 MAX Product Details: Aluminum UBC Scrap aluminum scrap cans Tape: according to the purity of aluminum, we can supply aluminum scrap with purity of aluminum 97%, 95%, 84%. Specification of Aluminum scrap 6063 Si : 0.2-0.6% Fe : 0.35% Cu : 0.1% Mn :0.1% Mg : 0.45-0.9% Cr :0.1% Zn :0.1%