Jinneng (Tanghai) Battery Construction Co., Ltd.

Characteristic  of 2200mAh Li-ion cylindrical battery Without special instructions, the following tests should be done under the condition of : temperature(23±3), atmospheric pressure (86KPaï½?106KPa), relative humidity (45%ï½?85%), and the tests should be done within two weeks after receiving the products. the definitions of some nomenclatures of this specification standard Charge: Charge with current 0.2C5A to limit charge voltage under the condition of23±3 surrounding temperature, then change to charge with constant voltage till the current less than or equal to 0.02C5A. Electrical Characteristic  for Cylindrical Rechargeable Electric vehicle li-ion Battery NO. Item Standard Test Method 1 Discharge rate capabilities Aï¼?1 C5A â?¥97% Bï¼?5 C5A â?¥95% Standard charged under the condition of normal atmospheric pressure and the environmental temperature of 23±3 and45%ï½?85%RH, then rest for 30mins and discharge at1C5Aã??5 C5Aã??10 C5A to the discharge cut-off voltage respectively. Charge/discharge cycle can be conducted for 3times before meeting the Standardsï¼?the same belowï¼? 2 capacity retention and recovery Residualcapacityâ?¥94 % Recoverablecapacityâ?¥*98% Standard charged under the condition of normal atmospheric pressure and the environmental temperature of 23±3ï¼? Stored for 28 days, then discharge at 0.2 C5A to 2.50Vmeasuring residual capacity; Then standard charge/discharge measure recoverable capacity.        3 Low TemperaturePerformance discharge capacityâ?¥85% rated capacityno distortion and no rupture The cell shall be charged in accordance with the standard charge. Then stored in the temperature of -10±1 for4h, Discharge at the constant current of 0.2C5A down to the end-of-discharge voltage 2.750V. 4 Cycle Life Charge: The cell shall be charged in accordance with RapidCharge condition. rest for 10mins.Discharge : 5C5A discharge to 2.75V, one cycle is finished, then rest for 30mins. Then repeat above steps, when capacity is less than 80% of initial capacity, the battery life is over.

Supplier: Cylindrical lithium-ion battery and a variety of battery packs

Warnings and Cautions in Using the Long life rechargeable lithium battery     To prevent a possibility of the battery from leaking, heating or explosion please observe the following precautions: When using a new battery for the first time or after long term storage, please use the battery charger specifically for that purpose fully charge the battery before use.  Do not disassemble or open, crush, bend or deform, puncture, or shred; Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to water or other liquids such as water, seawater, drinks such as soft drinks, juices, coffee or others, or expose to fire, explosion, or other hazard. Do not short circuit a battery or allow metallic or conductive objects to contact the battery terminals.  Avoid dropping the phone or battery. If the phone or battery is dropped, especially on a hard surface, and the user suspects damage, take it to a service center for inspection. The battery replacement shall be done only by either cells supplier or device supplier and never be done by the user.  Replace the battery only with another battery that has been qualified with the system per standard. Use of an unqualified battery may present a risk of fire, explosion, leakage, or other hazard.  Don't keep a battery at rest for a long time (over 6 months). Safety accident may happen when recharging battery which has a rest for a long time. In the event of a battery leak, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with large amounts of water and seek medical advice.  Battery usage by children should be supervised. Seek medical advice immediately if a battery has been swallowed Never disassemble cells. The disassembling may generate internal short circuit in the cell, which may cause firing or other problems.  Never incinerate nor dispose the cells in fire. These may cause firing of the cells, which is very dangerous and is prohibited. Do not remove the outer sleeve from a battery pack nor cut into its housing.  Do not mix our batteries with other battery brands or batteries of a different chemistry such as alkaline and zinc carbon.  Do not mix new batteries in use with semi-used batteries, over-discharge may occur.  Promptly dispose of used batteries in accordance with local regulations.

INR18650-1500mAh Battery,1500mAh Li-ion cylindrical battery,lithium ion battery,cylindrical power lithium-ion batteries 1500mAh Li-ion battery Product Details: NO.Items   Specifications   1Model  INR18650-1500  2Can Material Ni-Iron   3Rated Capacity 1500 mAh0.2C5A  4 Nominal Voltage  3.7V  5 Max. Charge Voltage  4.2 V  6 Discharge Cut-off Voltage  2.75V  7 Max. Charge Current  1 C5A  8Max. Continuous Discharge Current  20 A  9Max. Pulse Discharge Current 30A 2s pulse    10Max. Diameterinclude PVC 18.30 mm  11Max. Height (include PVC)  65.30mm  12Weight (Approx.)43.0g  13Impedance Max. at 1000Hz charged status    20 m 14 Charge Method (CC/CV) Standard  0.5 C5A 3hrs Quick1 C5A 2.5hrs.   15  Operating Temperature Charge 0-45 32oF 113oF Discharge -10 60 -4oF 140oF Storage -20 45 -4oF 113oF

Characteristic of Long life 18650 battery a.Environmental conditions Unless otherwise specified, all tests stated in this specification are conducted at temperature 23±3°and humidity under 65%. b. Measuring equipment (1) Amp-meter and volt-meter The amp-meter and volt-meter should have an accuracy of the grade 0.5mA and mV or higher. (3)Slide caliper The slide caliper should have 0.01 mm scale. (4)Impedance meter The impedance meter with AC 1kHz should be used. c. Standard charge charging the cell CCCV with charge current 0.5C, constant voltage 4.2V and 150mA cut-off in CV mode at 23 for capacity. d. Standard discharge capacity discharge current of 600mA(0.2C) with 2.5V cut-off at 23within 1hour after the standard charge.

INR18650-2000mAh battery,2200mAh Li-ion battery manufacturer,lithium ion battery for vacuum cleaner,High security lithium ion battery 2000mAh Li-ion cylindrical battery Product Details: NO.Items   Specifications  1Model  20P1 (INR18650-2000) 2Can Material Ni-Iron  3Min  Capacity 1950 mAhï¼?0.2Cï¼? 4Nominal Voltage  3.7V 5Max. Charge Voltage 4.2 V 6Discharge Cut-off Voltage 2.750V 7Max. Charge Current 4A 8Max. Continuous Discharge Current  20 A 9Max. Pulse Discharge Current 30Aï¼? 2s pulse  ï¼? 10Max. Diameterï¼?include PETï¼? 18.4±0.05 mm 11Max. Height (include PET) 65.25±0.15mm 12Weight (Approx.)43.0g 13Impedance ï¼?Max. at 1000Hzã??charged statusï¼? 15±3mΩ 14  Pack consistency  â?³Voltage â?³Impedance â?³Capacity 15 Charge Method (CC/CV) Standard  0.5 CÃ?3 hrs. Quick2CÃ?1.0 hrs. 16 Operating temperature (surface temperature) Charge 0ï½?45 Discharge -20ï½?75 Storage -20ï½?45