KJG series Paddle Dryer / Processor are highly efficient, mechanically agitated, indirect heat transfer devices that add or remove heat from a process mass. They are used for drying, heating, cooling, pasteurization, crystallizing, and reacting of pastes, cakes, powders, and granules. Dual counter-rotating shafts with unique intermeshing discs produce intimate mixing and optimize heat transfer. The use of hollow discs and drying chamber heating jacket for heat transfer results in a compact machine. The heat transfer medium: steam, hot water or hot oil is isolated from the process mass. The KJG series Paddle Dryer provides a reliable and efficient method for drying slurry, filter cakes and centrifuge concentrates. The exhaust gases can be treated by cyclone, condenser and scrubber to considerably reduce air contamination. For those wet materials of heat sensitive, easy oxidized, containing organic solvents which need to be recovered, vacuum design is available. Technical advantages 1) High thermal efficiency which can reach 95% 2) Heat transfer medium does not contact the product. 3) Gas is not used to convey the product. Off-gas flow is minimal. 4) Precise control of temperature 5) Uniform product quality, through mixing and movement of the product 6) Continuous process on a once-through basis 7) High heat transfer area to process volume ratio - reduced floor space 8) Easy to operate, requires minimal attention 9) Safer than direct drying when processing combustible material 10) Simple durable design for easy and low maintenance 11) Dual counter-rotating shafts with unique intermeshing discs produce intimate mixing, uniform heat transfer, a high heat transfer rate, and a self-cleaning effect.A large heat transfer area to volume ratio is achieved by the use of hollow discs and a jacketed vessel, through which the heating medium flows. The result is a compact machine with less space requirements and lower installation cost. 12) The KJG series Paddle Dryer transports material, regardless of its handling characteristics. Sticky, pasty materials can be transported. Pre-conditioning the feed by mixing with recycled dried product, to make it conveyable, is not required. This results in lower capital, operating, and maintenance cost.